GV-1000

    工作原理是：樣品中的有機物在紫外線（UV）的作用下被氧化成二氧化碳，二氧化碳的測定采用了電導率檢測技術。通過測定未經氧化的樣品的總無機碳（TIC或IC）濃度，和經氧化后得到的樣品的總碳（TC）濃度來計算總有機碳濃度?？傆袡C碳濃度即總碳濃度與總無機碳濃度之間的差值：TOC = TC–TIC。

    符合《美國藥典》、《歐洲藥典》以及《中國藥典》的要求，可廣泛應用于超純水、制藥用水、飲用水、生物化工產品等的有機碳含量的測定。

    本產品檢測TOC濃度從0.001mg/L到1.000mg/L的水樣。操作簡單，維護費用低，無需添加化學試劑，操作人員無需特殊培訓或專業化學知識。

水中總有機碳分析儀 技術參數
1. 電    源：220V±22V, 50Hz±1Hz, 100W
2. 檢測范圍：0.001 mg/L～1.000 mg/L
3. 檢測極限：0.001 mg/L
4. zui大允許誤差：±5%
5. 分析時間：4 min
6. 響應時間：15 min以內
7. 樣品溫度：1~95℃
8. 環境溫度：10~40℃    溫度變化在±5℃/d以內
9. 內部樣品流速：0.5 mL/min
10. 相對濕度：≤ 85%
11. 重復性誤差：≤ 3%
12. 零點漂移：±5%

水中總有機碳分析儀特點
1. 采用雙波長紫外光納米催化氧化法，其氧化能力較傳統的單波長紫外光氧化法提高100倍以上，靈敏度*，不需催化劑和載氣；
2. 二氧化鈦催化涂層螺旋管，特別適用于制藥用水測定有機碳含量；
3. 具有超出設定上限值時蜂鳴報警功能，保護儀器，防止誤操作；
4. 可選擇外接在線監測裝置，滿足在線監測的需要；
5. 可選配自動取樣裝置；
6. 符合CP2010版“總有機碳檢查法"及USP32-643章 系統適應性要求；
7. 針對TOC含量1.000mg/L以下的去離子水的檢測而設計，在線、離線檢測可以切換使用。
8. 能自動存儲zui近12個月連續檢測的數據，可以查詢任意一天的檢測記錄，并能打印檢測結果。
9. 檢測速度快，一次檢測分析時間不超過4分鐘。
10. 體積小、重量輕、耗能少、攜帶方便。
11. 易于按照USP <643>和EP <2.2.44>以及中國藥典附錄Ⅷ R所要求的TOC檢測方法進行系統適用性試驗。
16. 超大的320′234的點陣真彩顯示器以及人性化的界面，具有RS232數據接口和打印機接口。

應用范圍
1. 用于測試純水、制藥工業去離子水和注射用水的有機碳含量；
2. 制藥和生物化學清洗驗證：在制藥和生物化學制藥業處理過程中，監測在循環清洗；
3. 半導體中監測純化水中TOC的含量。

TOC（Total organic carbon）ANALYZER
GV-1000

Description
GV-1000 TOC analyzer is a high performance testing analysis instrument, with independent inlectual property rights. It can detect total organic carbon (TOC) contain in the testing water, by calculating it from total inorganic carbon (TIC) and total carbon (TC). GV-1000 analyzer operation principle is to oxidize microorganism by UV lamp and convert organic stuff into carbon dioxide. It adopts dual wavelength ultraviolet nano-catalytic oxidation method, with its oxidation capacity increased over 100 times than traditional single-wavelength ultraviolet oxidation. 
It can detect the ultrapure water which the TOC content is only 1μg/L, also can detect sample water which the TOC content reaches 1000μg/L.

This equipment is easy to operate, low maintenance, no need to add chemical reagent, and no need supply special training or professional chemical knowledge for operator.

It meets the latest requirements of "United States Pharmacopoeia", "European Pharmacopoeia" and "Chinese Pharmacopoeia", and it can be widely used to measure the organic carbon contained in ultra-pure, pharmaceutical water, drinking water, bio-chemical products, etc.

Technical parameter
Power supply:    AC220V±20V, 50Hz±1Hz, 100W
Test Limit:          0.001mg/L
Test precision:  ±5%
Test range:        0.001mg/L～1.0mg/L
Analyse time:    4min
Response time:           Within 15 min 
Sample temperature:  1-95℃
Ambient temperature: 10-40℃    Changing during ±5℃/d 
Inner sample speed:  0.5 ml/min
Relative humidity:        ≤85%
Repeat error:                ≤3%
Zero excursion:            ±5%
Measure excursion:    ±5%
Net weight::                 12kgs

Dimension:        39cm×20cm×22cm

Characteristic
1．Adopts ultraviolet catalytic oxidation method , do not need catalyst and carrier gas;
2．Has the function of buzzer alarm when it exceeds the upper limit value, which protects the device and avoids mis-operation;    
3．Optional external line monitoring devices, to meet the needs of online monitoring;  
4．Invent the titanium dioxide catalytic coating spiral pipe independently, which is designed for measuring the TOC contained in pharmaceutical water determination; 
5．Meet the"TOC Inspection Act" of CP2010 version and the system suitability requirements of USP chapter 32 to 643;  
6．Optional automatic sampling device;   
7．Achieve the CMC certification, Zhejiang system No. 01010406;
8．Without adding acid reagent, oxidants, and any gas, no additional maintenance fees;
9．It is simple, fast and reliable to operate, and users do not need expertise and specialized training; 
10．Design for deionized water (TOC content less than 1.000mg / L) test, detection mode can be switched off;
11．Continuous testing data of the last 12 months can be stored automatically and for reference , and it can save more than 5 years’ data. stores, you can check the record of any day . The test result can be printed out;
12．Good detection speed, detection time and analysis time less than 4 minutes;

13．Small size, light weight, low energy consumption;
14．With automatic limit alarm output function, it reminds the operator timely when data anomalies;
15．Easy to do the system suitability test that follows USP <643> and EP <2.2.44> and the Chinese Pharmacopoeia Appendix Ⅷ R: TOC detection methods requirements;
16．320 234 matrix TFT display and user-friendly interface, with RS232 data interface and printer interface.

Application
1. Measuring the TOC value contained in pure water, deionization water and WFI;
2. Pharmaceutical and biological chemical cleaning validation: The instrument can be used to monitor the water during circulation cleaning in pharmaceutical and biochemical  industry;
3. Monitor the TOC value contained in the purified water of semiconductors.

Requirement for testing water
Pharmaceutical water, electronic industry ultrapure water. Especially for deionization water.